![]() "Filewall Name" to create a host name for the machine.If you don't get the NIC2 attached to Internet and NIC1 attached to LAN like the installer expects, you get an "Internet Configuration" screen with error messages.(A checkbox checked by default): Install the latest firmware automatically during setup (recommended).Create New Admin Account: You enter a password.(Aside: PFSense / OPNSense can be configured with Let's Encrypt to present a good certificate.) After ignoring the warning, I got the configuration page: I was presented with an invalid SSL certificate warning "This site is not secure". I used the 172.16.16.16:4444/ link that the e-mailed instructions had. The command line on the monitor of the computer had a password prompt, but as shown in the wizard, it's useless because you're overwriting the password anyway. ![]() It took about 10 minutes for the firewall to start issuing DHCP and giving the computers IP addresses. Other than that, it seems to be running as I'm posting through the firewall right now. In my case, it turned out to be the farthest and second farthest ports from the motherboard on the add-on EXPI9404PTL card. Unlike the virtual machine however, pressing 'y' actually rebooted the machine at the end of the install.Īfter installation, I had to experiment plugging Ethernet cables into each of the six network adapters to find out what was "port 1" and "port 2". The installation screens looked exactly like the VM. The compatibility support mode was turned on to allow "legacy" boot. In addition to the 2 network adapters on the motherboard, I have 4 other adapters from an expansion card (an old IBM EXPI9404PTL). I installed on my desktop with the following: (although I did fill up the console with 'yyyyyyYYYY' trying) I resorted to a hard reset on the virtual machine. ![]() I ejected the virtual disk and pressed "Y", but I didn't get a reboot. The wizard just fails if you don't have that setup, so you may have to shut off the machine and swap cables around if you get the order wrong.Īfter about a minute of a blank screen (I was wondering if the installer was broken), I get this prompt to overwrite the entire contents of the one and only virtual hard drive.Īfter telling it to format the drive, it went into this text only installer, which took about 8 minutes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |